 |
 |
|
 |
|
| Author |
Message |
KPCS
Tinker
Joined: 01 Aug 2005
Posts: 47
Location: Michigan
|
 Posted: Mon Aug 17, 2009 7:48 pm Post subject: Shop Toys |
 |
|
I was working in the shop when I needed a Indexer to mill some flats on round stock.
I don't have a Hartford ( Super Spacer ) or a Hardinch ( Smaller type Super Spacer ).
I did remembered that I had gotten a new drill chuck.
Old Drill Chuck
New Drill Chuck
So now what can I do with the old drill chuck.
Hum. I remembered going to a NAMES show and picked up some blueprints on making a small Indexer with a drill chuck.
Well I have some stock in the shop.
When by the blueprints from the NAMES show I picked up and made this ......
Just thought you might like this...
Ken W
_________________
KPCS
Prototype
Restoration
Customization
Fabrication
Powder Coating
www.kpcspb.com
I'm just a glorified drill press operator. |
|
| Back to top |
|
|
|
|
 |
|
 |
|
|
|
|
| Author |
Message |
sniper1rfa
Burnout
Joined: 17 Sep 2005
Posts: 318
|
| Posted: Fri Aug 21, 2009 2:33 pm Post subject: |
|
|
that's pretty snazzy. I like it. :)
_________________
Remember kids, Alice says "Don't do drugs!" |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
|
| Author |
Message |
betasniper
Tinker
Joined: 07 Nov 2008
Posts: 35
Location: Corona, California
|
| Posted: Mon Aug 31, 2009 8:25 pm Post subject: |
|
|
That is a great use of an old Item. Nice job. 
_________________
as i lay in bed, i looked at the stars and though, where the heck is my ceiling? |
|
| Back to top |
|
|
|
|
|
|
|
|
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
|
|
|
|
|
